Suitable for all domestic and commercial applications that not only meet, but also exceeds building regulations. The system is designed with a comprehensive range of accessories such as integral box gutters, caps, vents, tie bars and an option of plain or decorative crestings, to enhance the overall elegance and functionality.

Special features

• Multi-angled roof system, custom manufactured to suit your requirements
• Energy efficient - compliant with Building Regulations
• Heavy duty glazing bars for maximum projection
• Structural ring beam - to incorporate folding sliding doors or sliding doors
• Increased ventilation - manual, electric and thermostatic controlled
• Severe weather and snow loading rated
• Polycarbonate or double glazed toughened glass units plus full range of finishes
• Low Maintenance and fully guaranteed

Versatility in design

The IDS70 roof system is manufactured from aluminium, which has been thermally broken by a two part polyurethane resin. Providing optimum strength, long life, with the ability to combat heat loss and prevent condensation.

Pitch The standard roof system can cater from a pitch of 5o through to 35o, and a greater pitch can be obtained with a bespoke wall bracket. By incorporating heavy duty glazing bars a 3000mm maximum projection can be accommodated with double-glazed toughened glass units - even greater with polycarbonate. Larger projections can be achieved, contact our technical department for details.       Structural ring beam A structural ring beam can create clear, unsupported span width openings of up to 5000mm, so you can accommodate folding sliding doors or sliding doors around the whole perimeter if required, with the weight of the roof above fully supported.       Ventilation Hot air rises, so with the addition of a roof vent(s), which can either be manually operated or thermostatically controlled with a rain sensor, you can be in complete control of the climate inside. The winding gear can be disengaged to enable access for cleaning etc. Increased ventilation and airflow can be generated with the option of a breathable back wall plate, which doubles as a night vent.       Weather Seals The IDS70 thermally broken roof system utilises both EPDM glazing gaskets and dual hardness gaskets for high performance, tested to CP3 Chapter V Part 2 for wind loadings (up to 100mph).       Operating System The roof system has been tested to BS6399:Part three and is able to withstand the dead load of several inches of snow, or take the load of maintenance boards to carry out work above the roof.       Appearance The standard finish is polyester powder coated White, other RAL colours (over 201 colours available), Silver or Bronze anodised or wood grain effect is available for a nominal charge.       Complete System I-D-Systems roof systems have been specially designed to complement our folding sliding doors and sliding door systems.       Glazing The system can accommodate glazing of up to a sealed unit of 28mm. Our standard 24mm unit comprises of 4mm clear toughened glass with Pilkington Optitherm or Saint-Gobain Planitherm soft-coat to the inner pane x 16mm argon gas cavity x 4mm clear toughened glass providing an enhanced thermal efficiency with a centre pane u-Value of 1.1W/m2K to comply with building regulations for safety and thermal efficiency. All sealed units are BS kite marked, manufactured to BS6206A and BS5713 standards. Polycarbonate sheeting, clear or tinted of 16mm or a full 25mm with a centre pane u-Value of 1.5W/m2K can alternatively be requested.       Installation All roof systems are pre-assembled in the factory to ensure everything runs smoothly and efficiently, at the time of installation. It should be noted that I-D-Systems does not undertake any site preparation, electrical or building works. Lead work and guttering can be quoted as an optional extra.